1 Piece Forged Wheels To Ensure Safety

1 Piece forged Wheels To ensure safety

Forging wheelsets are an important part of the car, when it goes wrong, we need to change them, so how do we do that? The following summary by Xiaobian for your introduction:

First, the wheel shaft coupling shaft connecting bolts removed; and then remove the wheel set angle bearing box and the end beam connected to the fastening bolts, with the car jack or jack lifting the car bridge, the wheel tread From the top of the track about lOmm, pry the wheel set and pull it out along the track surface to remove the replacement;

Next, put the pre-assembled, new and active wheelsets with shaft-end gear coupling halves on the car track, push the wheelsets close to the mounting position to ensure safety and adjust the jacks to slow the car body Drop, penetrate the fastening bolt, screw on the nut;

Appropriately tighten the bolts in the horizontal direction, and then tighten the bolts in the vertical direction. Turn the bolts alternately. While tightening, pull the wheels to check whether the wheels rotate freely and check the horizontal and vertical deflection of the wheels.

Align the shaft end gear coupling halves and the reducer driven shaft coupling halves of the screw holes, penetrate the connecting bolts and tighten. Everything is normal, the body falls.

The other end of the active wheels are also replaced with the same steps. In order to ensure consistent transmission at both ends, to ensure that the car is running properly, both ends of the active wheels must be replaced at the same time. Forging wheel set installation and removal of the operation requirements are there?

Forging wheelsets are an important part of the car, when it goes wrong, we need to change them, so how do we do that? The following summary by Xiaobian for your introduction:

First, the wheel shaft coupling shaft connecting bolts removed; and then remove the wheel set angle bearing box and the end beam connected to the fastening bolts, with the car jack or jack lifting the car bridge, the wheel tread From the top of the track about lOmm, pry the wheel set and pull it out along the track surface to remove the replacement;

Next, put the pre-assembled, new and active wheelsets with shaft-end gear coupling halves on the car track, push the wheelsets close to the mounting position to ensure safety and adjust the jacks to slow the car body Drop, penetrate the fastening bolt, screw on the nut;

Appropriately tighten the bolts in the horizontal direction, and then tighten the bolts in the vertical direction. Turn the bolts alternately. While tightening, pull the wheels to check whether the wheels rotate freely and check the horizontal and vertical deflection of the wheels.